"supply," CNS Standards Search Result |
CNS 16128
- English Version Stationary a.c. and d.c. conductive power supply systems for electric motorcycle − Digital communication between electric motorcycle dedicated d.c. power supply device and electric motorcycle for control of d.c. charging 電動機車定置式交流及直流傳導式供電系統-電動機車專用直流供電裝置與電動機車間充電控制用數位通訊 - 英文版 |
|
|
CNS 16127
- English Version Stationary a.c. and d.c. conductive power supply systems for electric motorcycle − Standard interface for d.c. power supply systems 電動機車定置式交流及直流傳導式供電系統-直流供電系統介面 - 英文版 |
|
|
CNS 16125
- English Version Stationary a.c. and d.c. conductive power supply systems for electric motorcycle − General requirement 電動機車定置式交流及直流傳導式供電系統-一般要求 - 英文版 |
|
|
CNS 16126
- English Version Stationary a.c. and d.c. conductive power supply systems for electric motorcycle − Battery swapping system 電動機車定置式交流及直流傳導式供電系統-電池交換系統 - 英文版 |
Translated |
|
CNS 12154
- English Version Uninterruptible Power supply System (UPS) 不中斷電源供應裝置 - 英文版 |
Translated |
|
CNS 2456-2
- English Version Plastics piping systems for water supply and for drainage and sewerage under pressure − Polyethylene (PE) − Part 1: General 壓力下給水、排水及排污用塑膠配管系統—聚乙烯(PE)—第2部:管 - 英文版 |
|
|
CNS 15274
- English Version Equipment for water supply service - Method of test for effect to water quality 自來水用器具-對水質影響試驗法 - 英文版 |
|
|
CNS 14934-3
- English Version Electromagnetic compatibility (EMC) - Limits - Part 3: Limitation of voltage changes, voltage fluctuations and flicker in public low-voltage supply systems, for equipment with rated current ≦16A per phase and not subject to conditional connection 電磁相容-限制值-第3部:每相額定電流在16 A以下且不屬於有條件連接之設備於公共低電壓電源系統中電壓改變、電壓變動及閃爍之限制值 - 英文版 |
|
|
CNS 4053-1
- English Version Unplasticized polyvinyl chloride (PVC-U) pipes for water supply 自來水用硬質聚氯乙烯塑膠管 - 英文版 |
Translated |
|
CNS 4053-1
- English Version Unplasticized polyvinyl chloride (PVC-U) pipes for water supply 自來水用硬質聚氯乙烯塑膠管 - 英文版 |
Translated |
|
CNS 17409
- English Version Electrically propelled road vehicles − Connection to an external electric power supply − Safety requirements 電動道路車輛-外部電源連接-安全要求 - 英文版 |
|
|
CNS 15511-21-2
- English Version Electric vehicle conductive charging system − Part 21-2: Electric vehicle requirements for conductive connection to an AC/DC supply − EMC requirements for off-board electric vehicle charging systems 電動車輛傳導式充電系統-第21-2部:電動車輛以傳導式連接至交流/直流電源的要求-非車載電動車輛充電系統的電磁相容要求 - 英文版 |
|
|
CNS 2456-1
- English Version Plastics piping systems for the supply of gaseous fuels − Polyethylene (PE) − Part 5: Fitness for purpose of the system 壓力下給水、排水及排污用塑膠配管系統-聚乙烯(PE)-第1部:通則 - 英文版 |
|
|
CNS 2456-5
- English Version Plastics piping systems for water supply and for drainage and sewerage under pressure − Polyethylene (PE) − Part 3: Fittings 壓力下給水、排水及排污用塑膠配管系統-聚乙烯(PE)-第5部:系統適合度 - 英文版 |
|
|
CNS 14934-5
- English Version Electromagnetic compatibility (EMC) - Limits - Part 5: Limitation of voltage fluctuations and flicker in low-voltage power supply systems for equipment with rated current greater than 16A 電磁相容-限制值-第5部:額定電流大於16 A之設備於低電壓電源系統中電壓變動及閃爍之限制值 - 英文版 |
|
|
CNS 14498-3
- English Version Road vehicles - Electrical disturbances from conduction and coupling - Part 3: Electrical transient transmission by capacitive and inductive coupling via lines other than supply lines 道路車輛-傳導及耦合之電擾動-第3部:電源線以外之導線以電容式或電感式耦合的電暫態傳輸 - 英文版 |
|
|
CNS 15423-1
- English Version Equipment for water supply service – Part 1: Test methods of hydrostatic pressure 自來水用器具-第1部:耐壓試驗法 - 英文版 |
|
|
CNS 2456-3
- English Version Plastics piping systems for water supply and for drainage and sewerage under pressure − Polyethylene (PE) − Part 2: Pipes 壓力下給水、排水及排污用塑膠配管系統-聚乙烯(PE)-第3部:管件 - 英文版 |
|
|
CNS 2334
- English Version Unplasticized polyvinyl chloride (PVC-U) pipe fittings for water supply 自來水用硬質聚氯乙烯塑膠管件 - 英文版 |
|
|
CNS 3223
- English Version Power-Supply, Half-Wave, Metallic, Rectifier, Stack for Radio Receivers, Amplifiers, Etc. (110 Volts to 130 Volts, a.c.) 聚丙烯織製無縫邊袋(五十公斤裝砂糖用) - 英文版 |
|
|
CNS 14934-4
- English Version Electromagnetic compatibility (EMC) - Limits - Part 4: Limitation of emission of harmonic current in low-voltage power supply systems for equipment with rated current greater than 16A 電磁相容-限制值-第4部:額定電流大於16 A之設備於低電壓電源系統中諧波電流發射之限制值 - 英文版 |
|
|
CNS 15423-6
- English Version Equipment for water supply service – Part 6: Test methods of durability 自來水用器具-第6部:耐久試驗法 - 英文版 |
|
|
CNS 28000
- English Version Specification for security management systems for the supply chain 供應鏈安全管理系統規範 - 英文版 |
|
|
CNS 15630
- English Version Self-ballasted LED lamps for general lighting services with supply voltages > 50 V − Performance requirements 一般照明用安定器內藏式LED 燈泡(供應電壓大於50 V)-性能要求 - 英文版 |
|
|
CNS 12835-2
- English Version Plastics piping systems for the supply of gaseous fuels – Polyethylene (PE) – Part 1: General 燃氣用塑膠配管系統-聚乙烯(PE)-第2部:管 - 英文版 |
|
|
CNS 15199
- English Version Electrical installations of buildings - Part 7-712: Requirements for special installations or locations - Solar photovoltaic (PV) power supply systems 建築物之電力安裝-第7-712部:特別設立或地點之要求-太陽光電電力供應系統 - 英文版 |
|
|
CNS 15423-3
- English Version Equipment for water supply service – Part 3: Test methods of water hammer 自來水用器具-第3部:水鎚試驗法 - 英文版 |
|
|
CNS 2334
- English Version Unplasticized polyvinyl chloride (PVC-U) pipe fittings for water supply 自來水用硬質聚氯乙烯塑膠管件 - 英文版 |
|
|
CNS 15423-2
- English Version Equipment for water supply service– Part 2: Test methods of low temperature resistant 自來水用器具-第2部:耐寒試驗法 - 英文版 |
|
|
CNS 11617
- English Version Socket-Outlet Elements for Power supply of Refrigerated Containers 冷凍貨櫃電源用出線插座元件 - 英文版 |
|
Find out:56Items | To Page of: First -Previous-Next -Last | 1 2 |